UPE1 - Flush-Mounted Radio Receiver (1 Channel)

No room to install a normal radio receiver? The solution is UPE1! The flush-mounted receiver is fitted either to a normal flush-mounted installation socket or, say, to a lamp socket, thereby being invisibly integrated into the wiring. If fitted to a deep flush-mounted socket, the UPE1, which is only 21 mm high, can also be installed behind a flat switch or such like, without losing the previous switching point. This converts a normal socket into a radio socket in next to no time.

The radio receiver has several operating modes that can be selected. In addition to the normal switch functions, there is also a switch-off timer, for, say, a staircase lighting control unit.


  • 1-channel radio receiver, 230V in 868 MHz  
  • Operating modes: pulse, surge, targeted ON/OFF
  • Switch-off timer, configurable from around 1 second up to around 18 hours
  • Relay output, 230V/AC, 2A potential-bound (switches “L”)


UPE1-868A100 UPE1-868A100


Reception frequency: 868.30 MHz/AM (see UPE1 label)
Reception channels: 1-channel receiver
Coding: 12-bit, 18-bit, or Keeloq, self-learning, max. 13 codes (transmitter keys) can be taught in
Antenna: integrated (no ext. antenna required)
Operating voltage: 230 V, ± 10% 50 Hz
Standby: < 1W
Input: ext. command input for buttons or switches 230V (L)
Output: 1 closing contact 230 V/AC 2 A ohmic load, switches (L)
Switch-off timer: programmable from 1s ... around 18h, in 1s increments
Operating temperature: -20° C up to +70° C at 35% to 85% relative humidity
Dimensions: approx. 46 mm x 46 mm x 21 mm, plastic housing, IP 20 (mounting straps can be broken off)
Weight: approx. 35 g


  • Order no. / EAN (GTIN)

    1-channel flush-mounted radio receiver

Consulting and sales only to the electronics and wholesale!